钉Yilid皮带传动离心风机Belt Driven Centrifugal Fan库使文用库册Handbook浙江亿利达风机有限公司ZHEJIANG YILIDA VENTILATOR CO.,LTDYilidYiliNote:The beit should be released if the does not run in a long time,and when the fan is to搬运、储存和防护方风机在出厂前已经过出厂检验合格并进行符合防护要求的包装。风机运输、装如和铭存风机应通过套在风机粗架四周的悦绳来吊装搬运，在吊装过程中如风机外壳表面擦伤应二、开机前检查步骤在风机首次投入使用前，必须道守木操作说明书所述内容，在完成下列步露后，风机才3、确保基座安装和管道联接在设计上完全符合工程惯例及厂商推荐内容：8、检查皮带轮是否对直，并采用厂家在荐的张景力：A2014请仔细检查以下儿项：大、BEARING LUBRICATION(5)皮带、皮带轮运转是否平稳，在确认以上检查无误后可以运行风机，但在首次运行的八小时内，应对风机的振动和噪出生产商推荐的范围。运行八小时后，夜关机并检查以下事项：12Yilid万Yilid(2》大小皮带轮的平面直线度有无变化：四、V-BELT DRIVE INSTALLATION(3》皮墙：动张紧度有无变化：三、风机安装指南35m/s (25-35m/s):皮毒传动离心风机安装时进出风管路安装不当会引起风机性能降低。进风口处受限加和五，BELT TENSIONIf a beit-tensioning gauge is not available,then the belt should be tightened jast enough so that theAfter tensioning the belt and before starting the ventilator,check to make sure that thepulley are proper aligned.Realign the pulley if necessary.Note that the new belts maystretch a little during initial use,so the belt tension level should be checked again after a